| |
|
THE GAPPER |
 |
The ultimate in spark plug gapping. Made of billet aluminum. Ease of use and consistent gaps are the key to this patent pending work of art. When you gap a set of plugs every pass…this is a true must have.
|
| |
 |
Power Ring Filer w/ Deburing Wheel
The most popular ring filer in the industry!
Ends tedious filing and rechecking to get desired gap. High torque motor cuts end gap fast. Powerful motors...no batteries to replace! Table pivots past grinding wheel. No open ways to accumulate grinding dust and wear prematurely. Knurled in-feed adjustment knob for extra control. The ultimate in ring filing!
|
 |
Valve Lash Adjuster Wrench
Made in the USA. This wrench torques your adjusters to 22 lbs every time. Comes with wrench and 3/16 T-handle hex (socket not included).
|
 |
Valve Spring Checker
A fast and easy, go-no go gauge to check valve spring pressure. Makes inbetween round maintance that much faster.
|
 |
Lencodrive Lift Kit
Make it easy to lift your Lencodrive in and out of the car with these billet handles
|
|
Valve Shim Remover
Remove valve spring shims with ease. Forget screwdrivers and air... 4 earth magnets evenly spaced and the hollow design make this tool a must have.
|
 |
Dual-Sided Head Washer Remover
Remove head washers with ease. Forget screwdrivers and air...4 earth magnets evenly spaced and the hollow design make this tool a must have. Fits 7/16" Studs and 1/2" Studs.
|
 |
Stud Installers and Removers
Stamped for easy ID. Installers have a steel ball to prevent overtightening. Remover body is 3/4" and hex jam is 5/8"
Available in sets or individual.
Sizes: 1/4-28, 5/16-24, 3/8-16, 3/8-24
7/16-20, 1/2-20, 9/16-18
|
|
Head Organizer
Tearing down or assembling heads, this organizer keeps everything in one place which cuts down on mistakes and makes for easier more efficient work. Quality finished wood craftsmanship eliminates parts scaring.
|
 |
Push Rod Stand
This stand keeps push rods organized when taking the heads off. A must have for between round thrashes or working at the shop. Quality finished wood craftsmanship eliminates parts scaring.
|
 |
Pre Run Spark Plug Holder
Once plugs are gapped, they now have a safe and convenient home. Cut down on between run time, this organizer holds enough plugs for four changes. Quality finished wood craftsmanship eliminates parts scaring.
|
 |
After Run Plug Holder
Trying to compare plugs from one pass to another can be difficult. This organizer holds up to 8 runs and keeps each cylinder in one line. Quality finished wood craftsmanship to eliminate parts scaring.
|
 |
Air Servo or Lever
Adjustment Wrench
Some things are just hard to find. This 'Made in the USA' Wrench is the correct angle and perfect thickness to adjust the nuts that hold air servos or levers.
|
 |
BC69 - Air Pressure Gauge
Make sure your Lenco shifts smoothly. This liquid filled guage is adapted to fit the 1/4" OD plastic line normally used to shift the Lencodrive. The Lencodrive like all CS2 modles needs 240 psi to shift. Reads: 0-400
|
| |
|
| |
|
| |
|
To Place an Order Call 219.987.2921
|
|
This website created and maintained by McSnyder Designs |
